![]() ![]() There are several magnetic wire fishing sets on the market, but it’s important to choose your magnet carefully. Once you feel the drop magnet near the exit hole, reach in, pull it out, and you’re all set! Slowly move your magnet around the wall until you feel the fishing bit’s magnetic pull. Don’t worry if you don’t feel it instantly. You should be able to feel the drop magnet stick to the wall and latch onto the handheld magnet. You may have to use short, repetitive stroking motions to move it through the insulation. Once the drop magnet is inserted, use the provided magnet to feed it through the wall. You may need to remove some insulation at the entry point so the drop magnet has space to enter the wall cavity. Once both holes are drilled, you can feed in your drop magnet. ![]() Note that the drop magnet is larger than the end of your average fishing rod, so you’ll need to drill a wider entry hole. This method involves pulling the magnetic tipped wire out of the exit hole by guiding it with a strong magnet rolled against the wall.Īttach your cable to the end of the drop magnet and drill your entry and exit holes. Using a magnetic fishing bit, or drop magnet, is one of the easiest ways to fish a wire through insulation. If you’re new to the world of wire fishing, watch the video to learn about the different fishing rods and their functions. Retrieve it from the exit hole and you’re good to go! Steadily, but firmly, push the wire down the wall. Try to get it as flush to the corner as possible before feeding it down the wall. This will make weaving the wire through much easier.Īttach the wire to the bull-nose tip and position it against the corner of the wall cavity. When drilling the entry and exit holes, position them near the corners of the wall and line them up as best as possible. If you don’t have a bull-nose tip, see the KOOTANS 11 ft Fiberglass Wire Running Kit, which includes all the wire fishing essentials. You will need a standard bull-nose (or loop) tip fiberglass rod. However, this is a great and easy option if the insulation is sparingly packed and fluffy. This may not be possible if you find that the insulation is very dense and stiff. ![]() Depending on the insulation, you may be able to feed the wire along the corner of the wall cavity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |